Ion Air Pro Body Cover Replacement - iFixit 수리 안내서

소개

This step is one of the longest steps to complete yet it is essential in order to replace the body cover. If the Ion Air Pro is unable to be mounted on because the body cover is damaged, the body cover will have to be replaced. Follow these steps carefully on how to remove the body cover.

필요한 것

1 단계 Body Cover

Ion Air Pro Body Cover Replacement, Body Cover: 1 단계, 이미지 1/1

Unscrew all six screws.
Make sure you put the screws in a good spot where you won't lose them because they are small.

2 단계

Ion Air Pro Body Cover Replacement: 2 단계, 이미지 1/1

After you're done with unscrewing, take off the blue lid shown here.

3 단계

Ion Air Pro Body Cover Replacement: 3 단계, 이미지 1/1

On the other side of the device, lift this black piece of cover that is underneath the cap, on the bottom side of the Ion Air Pro.

4 단계

Ion Air Pro Body Cover Replacement: 4 단계, 이미지 1/1

After removing the black lid, unscrew all eight screws here.
Again, make sure you keep track of your screws and don't lose them.

5 단계

Ion Air Pro Body Cover Replacement: 5 단계, 이미지 1/1

Remove two more screws, one on each side, inside this socket.

6 단계

Ion Air Pro Body Cover Replacement: 6 단계, 이미지 1/1

Next, unscrew the two screws located here.

7 단계

Ion Air Pro Body Cover Replacement: 7 단계, 이미지 1/1

Detach the bottom black piece off from the bottom side but do not disconnect it from the wires.
Everything inside is still connected with all the wires, so be careful not to pull too hard or else everything inside could fall out or get broken.

8 단계

Ion Air Pro Body Cover Replacement: 8 단계, 이미지 1/1

Finally, you can remove the body cover off and replace it with a new one if you have to.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Christopher Brandl

회원 가입일: 10/09/18

673 평판

안내서 5개 작성하였습니다

배지 +6개 더

팀

UW Stout, Team S6-G2, Ogden Fall 2018 UW Stout, Team S6-G2, Ogden Fall 2018 회원

UWSTOUT-OGDEN-F18S6G2

4 회원들

안내서 5개 작성하였습니다

댓글 4개

Hey Chris where can I buy a replacement body cover?

The thread of the screw socket on my ion air pro WiFi has worn out and it can no longer be screwed onto any mounts.

Sam s - 2019년 1월 5일 답글

I LOST THE LOSTTHE REAR COVER WHILE HUNTING. iS THERE A REPLACEMENT I CAN GET

mcbee1010 - 2019년 11월 10일 답글

i lost the rear cover cap while hunting. can i purchase a new one

mcbee1010 - 2019년 11월 10일 답글

Can you show a photo of the other side (compared to step 8) showing the mounting thread please?

Andrew Mawby - 2023년 11월 21일 답글

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 623