소개

This guide shows you how to replace the spring on the power button.

부품

부품은 필요하지 않습니다.

  1. Turn the device upside down so that the three rubber pads are facing up.
    • Turn the device upside down so that the three rubber pads are facing up.

    댓글 쓰기

  2. Use a heat gun (set to low) to apply heat  to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.
    • Use a heat gun (set to low) to apply heat to one of the rubber pads until you can easily remove the pad. This step takes around 5-7 minutes.

    댓글 쓰기

    • Remove the heated rubber pad with a plastic opening tool.

    • Repeat steps 2 and 3 for the two remaining rubber pads.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Remove the six 1cm T-10 torx screws on the bottom of the device (found under the rubber pads) using a T-10 Torx screwdriver.

    댓글 쓰기

    • Open the device along its seam.

    • Be careful when separating the device because there are wires connecting the two seperate halves.

    댓글 쓰기

    • Disconnect the ribbon cable connector from the top half of the device by pulling outward and parallel to the connecting pins.

    댓글 쓰기

    • Locate and disconnect the two molex connectors found on either side of the ribbon cable connector on the bottom half of the device.

    Where do I find these speakers

    HighChief - 답글

    • Pull the plastic button off the post.

    댓글 쓰기

    • Remove the metal U-clip (compressing the spring) with tweezers.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Janessa D Cabrera

회원 가입일: 2014년 01월 23일

478 평판

안내서 4개 작성하였습니다

Cal Poly, Team 9-28, Maness Winter 2014 Cal Poly, Team 9-28, Maness Winter 2014 회원

CPSU-MANESS-W14S9G28

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 9

전체 시간: 1,357