주요 콘텐츠로 건너뛰기

소개

Removal of the passenger side panel of the device will allow access to other internal components.

  1. Remove the four 1/8-inch black machine screws using a Phillips #00 screwdriver. Remove the four 1/8-inch black machine screws using a Phillips #00 screwdriver. Remove the four 1/8-inch black machine screws using a Phillips #00 screwdriver.
    • Remove the four 1/8-inch black machine screws using a Phillips #00 screwdriver.

  2. Remove three steel-finish, pan-head, 1/64 x 3/16" machine screws identified in the photograph, using the Phillips #0 screwdriver. Remove three steel-finish, pan-head, 1/64 x 3/16" machine screws identified in the photograph, using the Phillips #0 screwdriver.
    • Remove three steel-finish, pan-head, 1/64 x 3/16" machine screws identified in the photograph, using the Phillips #0 screwdriver.

  3. Using your fingers and/or a metal spudger, gently release the plastic locking tabs of the front panel assembly from the steel enclosure while prying the front panel assembly away from the steel enclosure with your fingers. Using your fingers and/or a metal spudger, gently release the plastic locking tabs of the front panel assembly from the steel enclosure while prying the front panel assembly away from the steel enclosure with your fingers. Using your fingers and/or a metal spudger, gently release the plastic locking tabs of the front panel assembly from the steel enclosure while prying the front panel assembly away from the steel enclosure with your fingers.
    • Using your fingers and/or a metal spudger, gently release the plastic locking tabs of the front panel assembly from the steel enclosure while prying the front panel assembly away from the steel enclosure with your fingers.

  4. Gently remove the front panel from the steel enclosure.
    • Gently remove the front panel from the steel enclosure.

  5. Gently separate the ribbon cable from from ZIF connector on the circuit board using a metal smudger. Be careful not to scratch or damage components or features of the circuit board with the metal spudger Be careful not to scratch or damage components or features of the circuit board with the metal spudger
    • Gently separate the ribbon cable from from ZIF connector on the circuit board using a metal smudger.

    • Be careful not to scratch or damage components or features of the circuit board with the metal spudger

  6. Remove seven 1/64 x 3/16" screws from the top panel using the Phillips #0 screwdriver. Remove the top panel. Remove the top panel.
    • Remove seven 1/64 x 3/16" screws from the top panel using the Phillips #0 screwdriver.

    • Remove the top panel.

  7. Remove the five pan-head, 1/64 x 3/16" machine screws using a Phillips #0 screwdriver. Remove the five pan-head, 1/64 x 3/16" machine screws using a Phillips #0 screwdriver. Remove the five pan-head, 1/64 x 3/16" machine screws using a Phillips #0 screwdriver.
    • Remove the five pan-head, 1/64 x 3/16" machine screws using a Phillips #0 screwdriver.

결론

To reassemble your device, follow these instructions in reverse order.

Marshall Andersen

회원 가입일: 2018년 10월 02일

665 평판

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 1

전체 시간: 71