기기를 수리하세요

수리할 권리

상점

Kenwood DNX571HD CD/DVD Drive Replacement

작성자 Wendy Zaballos (또 다른 기여자 4명)
  • 댓글 0
  • 즐겨찾기 0
  • 완료: 1

난이도

쉬움

단계

6

소요 시간

5 - 10 분

섹션

1

플래그

0

소개

If the CD/DVD drive in your Kenwood DNX571HD car stereo has stopped working, or has physically broken, follow this guide to remove the module and replace it with a new one.

도구

해당 도구 구매

부품

지정된 부품이 없습니다.

  1. Unscrew the four 3.5mm side screws with a Phillips #1 screwdriver. There are two screws per side.

    • Unscrew the four 3.5mm side screws with a Phillips #1 screwdriver.

    • There are two screws per side.

    편집

  2. Use a spudger to unhook the plastic clips on the sides and top of the front panel. There are two clips on each side and one clip on the top. Place the spudger between the plastic tab and the metal case and gently lift the spudger away from the case. Place the spudger between the plastic tab and the metal case and gently lift the spudger away from the case.

    • Use a spudger to unhook the plastic clips on the sides and top of the front panel. There are two clips on each side and one clip on the top.

    • Place the spudger between the plastic tab and the metal case and gently lift the spudger away from the case.

    편집

  4. Pull the top of the front panel out and down to remove front panel.

    • Pull the top of the front panel out and down to remove front panel.

    • Remove the front panel gently so as not to damage the ribbon cables behind it.

    편집

  5. Unscrew the three 5mm screws from the top of the device using a Phillips #1 screwdriver. Lift up to remove the top casing. Lift up to remove the top casing.

    • Unscrew the three 5mm screws from the top of the device using a Phillips #1 screwdriver.

    • Lift up to remove the top casing.

    편집

  6. Lift the CD drive carefully to expose the attached cable underneath.

    • Lift the CD drive carefully to expose the attached cable underneath.

    편집

  7. Flip up the black clasp with a spudger to disconnect the large white ribbon cable connecting the CD drive to the board underneath. Flip up the black clasp with a spudger to disconnect the large white ribbon cable connecting the CD drive to the board underneath.

    • Flip up the black clasp with a spudger to disconnect the large white ribbon cable connecting the CD drive to the board underneath.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 4명과 함께

Wendy Zaballos

회원 가입일: 2018년 09월 17일

886 평판

안내서 6개 작성하였습니다

배지: 7

배지 +4개 더

팀

Washington State, Team S1-G1, Hope Fall 2018 Washington State, Team S1-G1, Hope Fall 2018 회원

WSU-HOPE-F18S1G1

4 회원들

안내서 6개 작성하였습니다

댓글 0개

의견 추가하세요

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 15

전체 시간: 351