이 버전에는 잘못된 편집 사항이 있을 수 있습니다. 최신 확인된 스냅샷으로 전환하십시오.
필요한 것
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Flip over the phone so that the back is facing up.
-
Pressing your thumb against the back cover, slide the cover off of the phone.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Use the iFixit opening tool to pry out the two tabs at the top corners of the battery compartment.
-
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Use a T6 Torx screwdriver to remove the four 7.6 mm screws at the corners of the battery compartment.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Open the phone and turn it on its side. You will see a seam around the Nokia’s side.
-
Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Use your hand to gently pull off the back panel from the bottom half of the phone.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Close the phone and place it on a flat surface.
-
Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Pry the keypad out with the plastic opening tool once the motherboard is moved out of the way.
-
다른 한 분이 해당 안내서를 완성하였습니다.