메인 콘텐츠로 스킵하기
  1. Open up the device by using a plastic opening tool in order to avoid damaging the device. To do so, find the seam along the outer edge of the device and use the plastic tool to pry the back panel up. Doing so may take some force and patience. To do so, find the seam along the outer edge of the device and use the plastic tool to pry the back panel up. Doing so may take some force and patience.
    • Open up the device by using a plastic opening tool in order to avoid damaging the device.

    • To do so, find the seam along the outer edge of the device and use the plastic tool to pry the back panel up. Doing so may take some force and patience.

  2. There are (4) 3mm T4 Torx screws between both speakers (two each). Remove the ones necessary for whichever speaker needs to be replaced. There are (4) 3mm T4 Torx screws between both speakers (two each). Remove the ones necessary for whichever speaker needs to be replaced. There are (4) 3mm T4 Torx screws between both speakers (two each). Remove the ones necessary for whichever speaker needs to be replaced.
    • There are (4) 3mm T4 Torx screws between both speakers (two each). Remove the ones necessary for whichever speaker needs to be replaced.

  3. 아이폰 배터리 수리 키트

    Only $29.99

    Buy Now

    아이폰 배터리 수리 키트

    Only $29.99

    Buy Now
  4. After the screws are removed, locate the wire, follow it to where it connects to the main device, and pull up gently until it disconnects. After the screws are removed, locate the wire, follow it to where it connects to the main device, and pull up gently until it disconnects. After the screws are removed, locate the wire, follow it to where it connects to the main device, and pull up gently until it disconnects.
    • After the screws are removed, locate the wire, follow it to where it connects to the main device, and pull up gently until it disconnects.

  5. Remove (2) 3mm T4 Torx screws from the bottom speaker. Remove (2) 3mm T4 Torx screws from the bottom speaker.
    • Remove (2) 3mm T4 Torx screws from the bottom speaker.

  6. Same as Step 3, after the screws are removed, follow the wire to where it connects and pull up gently until it disconnects. Same as Step 3, after the screws are removed, follow the wire to where it connects and pull up gently until it disconnects.
    • Same as Step 3, after the screws are removed, follow the wire to where it connects and pull up gently until it disconnects.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

aaa

회원 가입일: 2016년 10월 06일

671 평판

안내서 5개 작성하였습니다

USF Tampa, Team 2-3, Sullivan Fall 2016 USF Tampa, Team 2-3, Sullivan Fall 2016 회원

USFT-SULLIVAN-F16S2G3

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 5

전체 시간: 220