주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

Is your Kindle Fire HDX 7” not listening to you anymore? Don’t pull out the sleeper sofa just yet.

Replace the microphone by following this guide and see if it restores the communication between you and your tablet.

  1. Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet. The adhesive is strong and may require an iOpener, or heat gun, to soften. The adhesive is strong and may require an iOpener, or heat gun, to soften.
    • Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.

    • The adhesive is strong and may require an iOpener, or heat gun, to soften.

  2. Remove the speaker bezel.
    • Remove the speaker bezel.

  3. Remove the six pink 3mm T3 Torx screws from the back case.
    • Remove the six pink 3mm T3 Torx screws from the back case.

  4. Essential Electronics Toolkit

    Small Toolkit. Big Possibilities.

    Shop Toolkits

    Essential
    Electronics
    Toolkit

    Shop Toolkits
  5. Wedge opening picks around the perimeter between the display and back case. Work the opening picks around the perimeter until the two halves disengage from each other.
    • Wedge opening picks around the perimeter between the display and back case.

    • Work the opening picks around the perimeter until the two halves disengage from each other.

    • Don't completely separate as the display ribbon cable still connects the two.

  6. Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.
    • Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.

  7. Pry up the left speaker with the flat end of a spudger and remove. Pry up the left speaker with the flat end of a spudger and remove.
    • Pry up the left speaker with the flat end of a spudger and remove.

  8. Pry up the right speaker with the flat end of a spudger and remove. Pry up the right speaker with the flat end of a spudger and remove.
    • Pry up the right speaker with the flat end of a spudger and remove.

  9. Pry up the microphone connector from the rear panel with the flat end of a spudger. Pull up on the microphone with a pair of tweezers to remove. Pull up on the microphone with a pair of tweezers to remove.
    • Pry up the microphone connector from the rear panel with the flat end of a spudger.

    • Pull up on the microphone with a pair of tweezers to remove.

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Blake Klein

회원 가입일: 2017년 01월 29일

51,805 평판

안내서 49개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 3

7일 전: 6

30일 전: 17

전체 시간: 201