소개

This guide will help shorten the steps of each guide required for the replacement of each component.

  1. Turn the device so the two bottom screws are shown.
    • Turn the device so the two bottom screws are shown.

  2. Remove the two 7mm screws holding the back panel of the phone using the P5 bit and magnetic driver.
    • Remove the two 7mm screws holding the back panel of the phone using the P5 bit and magnetic driver.

    • Carefully use the plastic opening tool to pry the back panel of the phone from the front screen. This will expose the battery and other parts.

    • Use the Phillips #0 screwdriver to remove the 5mm screw holding the metal bracket that protects the battery's ribbon cable.

    • Carefully use the plastic opening tool to pry the ribbon cable connecting the battery to the motherboard of the phone.

    • Gently raise the battery from its compartment.

    • Remove the thirteen 5mm screws holding the plastic shield covering the motherboard using the Phillips #00 screwdriver.

    • Carefully use the plastic opening tool to pry the plastic shield from the motherboard. This will expose the motherboard and ribbon cables for each component.

결론

To reassemble your device, follow these instructions in reverse order.

Thomas Morrissey

회원 가입일: 2018년 10월 25일

589 평판

안내서 6개 작성하였습니다

UMass Dartmouth, Team S3-G4, Peak Fall 2018 UMass Dartmouth, Team S3-G4, Peak Fall 2018 회원

UMASSD-PEAK-F18S3G4

3 회원들

안내서 6개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 25

전체 시간: 44