기기를 수리하세요 커뮤니티 상점

LG K7 Rear Facing Camera Replacement

소개

Your rear camera may be broken, cracked, or otherwise not working. This guide will instruct you on how to remove your faulty rear camera.

필요한 것

  1. LG K7 Rear Facing Camera Replacement, Battery: 1 단계, 이미지 1/2 LG K7 Rear Facing Camera Replacement, Battery: 1 단계, 이미지 2/2

    • Place a fingernail in slot at in the bottom edge of the phone.

    • Pull up on the back panel while holding down the rest of the phone steady with your hand.

    • Do not to pull too hard on the back panel or you may break it.

    편집

  2. LG K7 Rear Facing Camera Replacement: 2 단계, 이미지 1/2 LG K7 Rear Facing Camera Replacement: 2 단계, 이미지 2/2

    • Place a fingernail in the slot at the bottom edge of the battery.

    • Pull the battery out.

    편집

  4. LG K7 Rear Facing Camera Replacement, Rear Facing Camera: 3 단계, 이미지 1/3 LG K7 Rear Facing Camera Replacement, Rear Facing Camera: 3 단계, 이미지 2/3 LG K7 Rear Facing Camera Replacement, Rear Facing Camera: 3 단계, 이미지 3/3

    • Remove the 9 frame screws with a JIS #00 screwdriver.

    • The bottom three screws release the port cover at the bottom of the phone. The cover should lift off easily once the screws are out.

    • Pop the camera button frame off with a spudger. The home button should come off along with the frame.

    • Be gentle with the frame when removing it. The plastic is very thin and can easily break.

    편집

  5. LG K7 Rear Facing Camera Replacement: 4 단계, 이미지 1/2 LG K7 Rear Facing Camera Replacement: 4 단계, 이미지 2/2

    • Use a plastic opening tool to separate the screen from the outer frame.

    • Do not to bend the outer frame or the screen to when separating them. This can severely damage the phone.

    편집

  6. LG K7 Rear Facing Camera Replacement: 5 단계, 이미지 1/1

    • Insert the edge of a plastic opening tool underneath the camera connector that is attached to the camera by a flat, thin, and flexible sheet.

    • Slowly lever the connector free by pressing down on the opening tool's handle. The connector should be fairly solid and pop out by levering just one edge.

    • Be careful not to break or bend the connector or any part of the device you may be levering against.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 1명과 함께

James Ngo

회원 가입일: 01/19/18

461 평판

안내서 4개 작성하였습니다

배지: 7

배지 +4개 더

팀

Cal Poly, Team S21-G5, Banghart Winter 2018 Cal Poly, Team S21-G5, Banghart Winter 2018 회원

CPSU-BANGHART-W18S21G5

4 회원들

안내서 8개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 4

30일 전: 8

전체 시간: 407