메뉴

설정

내 작업대

귀하의 기기에 대한 안내서, 부품 및 답변에 신속히 접근할 수 있습니다
내 장바구니

장바구니가 비어 있는 것 같습니다

상점 둘러보기

LG L1200 Keypad Replacement

작성자 Joshua Herrmann (또 다른 기여자 5명)
  • 댓글 0
  • 즐겨찾기 1

난이도

보통

단계

10

소요 시간

15 분

섹션

2

플래그

0

소개

This guide will help you replace the keypad of the phone.

도구

해당 도구 구매

부품

부품은 필요하지 않습니다.

  1. Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

    • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

    • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

    편집

  2. Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

    • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

    편집

  3. Use IPod opening tool to separate back housing.

    • Use IPod opening tool to separate back housing.

    • There are two tabs located on either side of the phone.

    편집

  4. Separate the back housing from the phone.

    • Separate the back housing from the phone.

    • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

    편집

  5. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기

  6. Use a spudger to disconnect antenna wire.

    • Use a spudger to disconnect antenna wire.

    편집

  7. Use the IPod opening tool to pop out the logic board.

    • Use the IPod opening tool to pop out the logic board.

    편집

  8. Use the IPod opening tool to disconnect the main ribbon.

    • Use the IPod opening tool to disconnect the main ribbon.

    편집

  9. Once the ribbon is detached, remove the logic board and replace if necessary.

    • Once the ribbon is detached, remove the logic board and replace if necessary.

    편집

  10. The back of the keypad is shown here, next to the logic board (the logic board is turned over to expose the buttons).

    • The back of the keypad is shown here, next to the logic board (the logic board is turned over to expose the buttons).

    편집

  11. Using a spudger, lift the keypad off of the tabs. Using a spudger, lift the keypad off of the tabs.

    • Using a spudger, lift the keypad off of the tabs.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 5명과 함께

Joshua Herrmann

회원 가입일: 2010년 04월 16일

8 평판

안내서 8개 작성하였습니다

배지: 3

팀

Cal Poly, Team 6-14, Maness Spring 2010 Cal Poly, Team 6-14, Maness Spring 2010 회원

CPSU-MANESS-S10S6G14

4 회원들

안내서 16개 작성하였습니다

댓글 0개

의견 추가하세요

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 2

전체 시간: 999