취소

LG VX5200 Screen Replacement

작성자 jmarcum (또 다른 기여자 6명)

댓글 1
즐겨찾기 0

LG VX5200 Screen Replacement

난이도

보통

단계

5

소요 시간

10 분

소개

This section covers how to disassemble the upper casing of the LG VX5200 to access the phone's screen.

도구

해당 도구 구매

부품

부품은 필요하지 않습니다.

1 단계 Screen

Pry the grey pieces of plastic off the corners of the screen with a spudger.

Pry the grey pieces of plastic off the corners of the screen with a spudger.

Pry the grey pieces of plastic off the corners of the screen with a spudger.

Pry the grey pieces of plastic off the corners of the screen with a spudger.

2 단계

Unscrew each of the four screws with a Phillips #00 Screwdriver.

These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.

Unscrew each of the four screws with a Phillips #00 Screwdriver.
These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.
These screws are the same size as the ones from the back casing, but are not the same size as the screw from the antenna.

3 단계

Close the phone after removing the screws.

Slide a spudger into the cracks in the top half of the phone's casing.

Close the phone after removing the screws.
Slide a spudger into the cracks in the top half of the phone's casing.
Wedge and lever the spudger to remove the casing.
Apply constant pressure to avoid cracking the plastic casing. This step can take a few minutes.

4 단계

Remove the chipboard from the screen by sliding a plastic spudger under the screen and lifting.

Use a plastic spudger to avoid short-circuiting the phone's electronics.

Gently lift the speaker out of the plastic casing using a plastic spudger.

Remove the chipboard from the screen by sliding a plastic spudger under the screen and lifting.
Use a plastic spudger to avoid short-circuiting the phone's electronics.
Gently lift the speaker out of the plastic casing using a plastic spudger.
Remove the small battery adjacent to the speaker with a plastic spudger.

5 단계

Slide and lever a plastic spudger between the screen and it's housing.

Avoid tearing the wires connecting the screen, the small battery and the speaker.

Remove the chip connecting the screen to the camera using your fingers.

Slide and lever a plastic spudger between the screen and it's housing.
Avoid tearing the wires connecting the screen, the small battery and the speaker.
Remove the chip connecting the screen to the camera using your fingers.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 6명과 함께

jmarcum

회원 가입일: 2009년 10월 28일

16 평판

안내서 1개 작성함

배지 +3개 더

팀

Cal Poly, Team 9-18, Regan Fall 2009 Cal Poly, Team 9-18, Regan Fall 2009 회원

CPSU-REGAN-F09S9G18

5 회원들

안내서 2개 작성하였습니다

댓글 한 개

의견 추가하세요

The “battery” beside the speaker isn’t the battery, it’s the phone vibrator. Still a good guide, however

Kaleb White - 2018년 11월 30일 답글

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 3,313