소개

The hard drive is likely to malfunction when dropped or put under a lot of stress. If the computer won't boot and is having hard disk/hard drive reading errors, follow this guide to replace it.

Turn off the computer.
  • Turn off the computer.

  • Disconnect the charging cable from the computer.

  • Failure to unplug the cable could result in electric shock.

  • Flip the computer upside down.

댓글 쓰기

Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position. Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position.
  • Locate the two switches that lock the battery. Push the right-hand switch outward into the "unlocked" position.

댓글 쓰기

Push and hold the left hand switch outward in the "unlocked" position, then gently slide the battery away from the computer.
  • Push and hold the left hand switch outward in the "unlocked" position, then gently slide the battery away from the computer.

댓글 쓰기

Remove the seven 5.3 mm Phillips  #1 screws holding the back panel in place.
  • Remove the seven 5.3 mm Phillips #1 screws holding the back panel in place.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly. If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.
  • Pull the back panel off using the highlighted tab. The tab should give you enough leverage to pull the panel off smoothly.

  • If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are removed before attempting again.

댓글 쓰기

The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.
  • The computer should be open with many of the internal components shown. You can now access the hard drive, the RAM, and the keyboard.

댓글 쓰기

Remove the two 5.33 mm Phillips #1 screws holding the hard drive in place.
  • Remove the two 5.33 mm Phillips #1 screws holding the hard drive in place.

  • Be careful with these screws, as they can be stripped or lost easily.

댓글 쓰기

To remove the hard drive from the computer, grab the black tab attached to the hard drive and pull the tab downwards toward the bottom of the laptop.
  • To remove the hard drive from the computer, grab the black tab attached to the hard drive and pull the tab downwards toward the bottom of the laptop.

  • When installing the hard drive, make sure the hard drive label faces down.

댓글 쓰기

Unscrew the four 5.2 mm Phillips #1 screws. There are two on each side of the drive holding it in the drive bay.
  • Unscrew the four 5.2 mm Phillips #1 screws. There are two on each side of the drive holding it in the drive bay.

댓글 쓰기

Pull the drive out of the bay. If all the screws were removed correctly, it should simply slide out.
  • Pull the drive out of the bay. If all the screws were removed correctly, it should simply slide out.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 7명이 해당 안내서를 완성하였습니다.

Dennis Wong

회원 가입일: 2013년 01월 11일

468 평판

안내서 5개 작성하였습니다

Cal Poly, Team 18-40, Regan Winter 2013 Cal Poly, Team 18-40, Regan Winter 2013 회원

CPSU-REGAN-W13S18G40

5 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 5

지난 7일: 29

지난 30일: 123

전체 시간: 17,686