기기를 수리하세요 커뮤니티 상점

Lenovo Ideatab S6000 Rear Camera Replacement

필요한 것

  1. Lenovo Ideatab S6000 Rear Camera Replacement, Battery: 1 단계, 이미지 1/1

    • Remove the speaker screens by working them loose with a plastic opening tool. You may need to first loosen them with tweezers or a craft knife.

    • These screens are held in place by glue that is hard to remove. Please take your time to ensure that that this step is done correctly.

    번역하기

  2. Lenovo Ideatab S6000 Rear Camera Replacement: 2 단계, 이미지 1/1

    • Remove the screws from both of the spots that were covered.

    번역하기

  3. Lenovo Ideatab S6000 Rear Camera Replacement: 3 단계, 이미지 1/1

    • DO NOT USE A METAL TOOL FOR THIS.

    • Go all around the casing, prying the screen away from the backing with the spudger.

    • It will make a popping sound each time one of the lock tabs is disconnected.

    • Take your time as you move all around the device when prying the backing off.

    번역하기

  5. Lenovo Ideatab S6000 Rear Camera Replacement: 4 단계, 이미지 1/1

    • Pull off the plastic that is covering the battery cable.

    번역하기

  6. Lenovo Ideatab S6000 Rear Camera Replacement: 5 단계, 이미지 1/2 Lenovo Ideatab S6000 Rear Camera Replacement: 5 단계, 이미지 2/2

    • Using either the plastic opening tool or your fingers, gently pull on both sides of the plug to release it.

    번역하기

  7. Lenovo Ideatab S6000 Rear Camera Replacement: 6 단계, 이미지 1/1

    • Remove the battery by grabbing the tab shown and pulling up.

    • The battery is held to the device by adhesive. Pull the battery up from the tab and it will lift out with a bit of effort.

    번역하기

  8. Lenovo Ideatab S6000 Rear Camera Replacement, Rear Camera: 7 단계, 이미지 1/1

    • Gently lift up on the metal connector plate.

    번역하기

  9. Lenovo Ideatab S6000 Rear Camera Replacement, Removing Rear Facing Camera.: 8 단계, 이미지 1/2 Lenovo Ideatab S6000 Rear Camera Replacement, Removing Rear Facing Camera.: 8 단계, 이미지 2/2

    • Push against the camera from all sides to loosen it from its position.

    • NOTE: The camera is connected by glue, so take your time, it will come out.

    • If you wish to replace the camera simply plug in the new camera, and follow the guide in reverse.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 3명과 함께

Josiah Speed

회원 가입일: 09/22/14

965 평판

안내서 4개 작성하였습니다

배지: 16

배지 +13개 더

팀

USF Tampa, Team 10-4, Brown Fall 2014 USF Tampa, Team 10-4, Brown Fall 2014 회원

USFT-BROWN-F14S10G4

4 회원들

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 818