기기를 수리하세요 커뮤니티 상점

Logitech Harmony 950 Case Replacement

소개

This guide will involve using basic tools to replace the case of the Logitech Harmony 950.

필요한 것

  1. Logitech Harmony 950 Case Replacement, Battery: 1 단계, 이미지 1/2 Logitech Harmony 950 Case Replacement, Battery: 1 단계, 이미지 2/2

    • Make sure the remote control is powered off before starting.

    • Use the Opening Tool to open the port cover at the bottom of the remote control.

    • Bend the cover back to gain easy access to the screws.

    편집

  2. Logitech Harmony 950 Case Replacement: 2 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 2 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 2 단계, 이미지 3/3

    • Use the Phillips #0 Screwdriver to remove the (2) two 6mm screws.

    • Pull the bottom cover off of the remote control.

    편집

  3. Logitech Harmony 950 Case Replacement: 3 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 3 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 3 단계, 이미지 3/3

    • Use the Phillips #1 Screwdriver to remove the (2) two 6mm screws.

    • There should be a gap on each side to fit the Opening Tool. Use the Opening Tool to open the back cover (Soft Touch cover) using the gap.

    편집

  4. Logitech Harmony 950 Case Replacement: 4 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 4 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 4 단계, 이미지 3/3

    • Use the Opening Tool to lift the battery out of the case.

    • Gently pull the cable out of the socket to unplug the battery.

    • Be careful not to damage any part of the remote when pulling the cable out.

    편집

  6. Logitech Harmony 950 Case Replacement, Case: 5 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement, Case: 5 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement, Case: 5 단계, 이미지 3/3

    • Use the Phillips #1 screwdriver to remove the (3) three 6mm screws.

    • Push the opening tool into the gap along the side of the remote, then slide it across until you hear clicking sounds.

    • You need to repeat this process for both sides of the remote.

    편집

  7. Logitech Harmony 950 Case Replacement: 6 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 6 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 6 단계, 이미지 3/3

    • Carefully remove the back cover and place it next to the remote. Be careful not to detach the wire during this process.

    • Use the Angled Tweezers to carefully pull the white cable end off of the remote and disconnect it.

    편집

  8. Logitech Harmony 950 Case Replacement: 7 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 7 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 7 단계, 이미지 3/3

    • Use the Phillips #0 screwdriver to remove the (5) five 6mm screws. Keep in mind that once the screws are off, the circuit board will be completely separate from the case.

    • Be careful not to damage or disconnect the pink wires when removing the gold charging conductors from the case.

    편집

  9. Logitech Harmony 950 Case Replacement: 8 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 8 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 8 단계, 이미지 3/3

    • Remove the black tape to fully access the cable underneath.

    • This cable has a locking mechanism. Use the Angled Tweezers to lift the black part (lock).

    • Slide the yellow cable to disconnect it from the circuit board.

    편집

  10. Logitech Harmony 950 Case Replacement: 9 단계, 이미지 1/2 Logitech Harmony 950 Case Replacement: 9 단계, 이미지 2/2

    • Pull the circuit board off of the case. Start from the bottom, and lift up to completely detach it from the cover.

    편집

  11. Logitech Harmony 950 Case Replacement: 10 단계, 이미지 1/3 Logitech Harmony 950 Case Replacement: 10 단계, 이미지 2/3 Logitech Harmony 950 Case Replacement: 10 단계, 이미지 3/3

    • Use the Blunt Tweezers to carefully remove the keypad from the cover of the remote.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

다른 3명이 해당 안내서를 완성하였습니다.

작성자

다른 기여자 5명과 함께

Shiba Kandel

회원 가입일: 09/26/17

149 평판

안내서 1개 작성함

배지: 9

배지 +6개 더

팀

USF Tampa, Team S2-G2, Passmore Fall 2017 USF Tampa, Team S2-G2, Passmore Fall 2017 회원

USFT-PASSMORE-F17S2G2

4 회원들

안내서 4개 작성하였습니다

댓글 3개

where can this casing be purchased?

Sharonda Bailey - 답글

Parts are required obviously!!

larrybud2004 - 답글

Is the usb bottom cap part of the replacement case? If not can u get one?

jmorrissette - 답글

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 8

30일 전: 43

전체 시간: 3,542