MNT Reform SSD Replacement

Neelfyn 및 다른 한 명의 기여자

최종 수정일 July 29, 2022

10 분

쉬움

커뮤니티-기여 안내서

소개

1단계로 이동하기

Use this guide to upgrade or replace the solid-state drive in your MNT Reform. Reform uses a standard M.2 M-key socket for NVMe SSDs.

Before you perform this repair, if at all possible, back up your existing SSD.

필요한 것

도구

Phillips #0 Screwdriver

1 단계 Remove Bottom Plate Screws

MNT Reform SSD Replacement, Remove Bottom Plate Screws: 1 단계, 이미지 1개 중 1개

Remove the following screws securing the transparent acrylic bottom plate to the main box:
Ten M2×6mm silver Phillips screws

편집

2 단계 Remove Bottom Plate

MNT Reform SSD Replacement, Remove Bottom Plate: 2 단계, 이미지 1개 중 1개

Lift the bottom plate and set it aside.
Before servicing anything on the inside, make sure to remove all battery cells.

편집

3 단계 Remove Battery Cells

MNT Reform SSD Replacement, Remove Battery Cells: 3 단계, 이미지 2개 중 1개

MNT Reform SSD Replacement, Remove Battery Cells: 3 단계, 이미지 2개 중 2개

Pull out the eight battery cells one by one, and set them aside safely.
Do not use a metal tool to remove the batteries. You may accidentally short-circuit the metal pins of the battery holders.
When replacing the batteries, pay attention to the polarity! Inserting a cell the wrong way in will damage your device.
The circuit board indicates the + and - orientation for each cell.

편집

4 단계 Remove SSD Screw

MNT Reform SSD Replacement, Remove SSD Screw: 4 단계, 이미지 1개 중 1개

Remove the single M2×4 pan head screw securing the SSD to the motherboard.

편집

5 단계 Remove SSD

MNT Reform SSD Replacement, Remove SSD: 5 단계, 이미지 3개 중 1개

MNT Reform SSD Replacement, Remove SSD: 5 단계, 이미지 3개 중 2개

MNT Reform SSD Replacement, Remove SSD: 5 단계, 이미지 3개 중 3개

Lift the free end of the SSD up slightly and pull the SSD straight out of its M.2 socket on the motherboard.
To avoid damaging its socket on the motherboard, do not excessively lift the free end of the SSD.

편집

결론

To reassemble your device, follow these instructions in reverse order. Ensure that no cables are squeezed when replacing the bottom plate. Don’t overtighten screws.

다른 한 분이 해당 안내서를 완성하였습니다.