소개

Remove the bottom cover to access components inside your Mac mini Mid 2011.

도구

도구는 필요하지 않습니다.

Place your thumbs in the depressions cut into the bottom cover.
  • Place your thumbs in the depressions cut into the bottom cover.

  • Rotate the bottom cover counter-clockwise until the white dot painted on the bottom cover is aligned with the ring inscribed on the outer case.

    • You do not need to apply much downward pressure while turning.

This took a lot of force on my Mac mini. A lot.

nh3 - 답글

I agree. It took a crap ton of force from my thumbs to twist the bottom off.

sleeve -

I accidentally broke the little things that hold the cover to the case. Is there a cheap replacement to the cover? Those clips are held onto it very weakly.

Jacob Halton - 답글

Don't just use your thumbs... Use your whole palm to twist it, with maybe a thumb in one of the recesses, applying slight downward pressure.

markbart - 답글

I think it depends, I have seen some that are very difficult to open and some super easy. But I see them everyday. I wish there was a tool that fit in the holes.

Justin Weathersbee - 답글

When seating the bottom RAM chip you may have to apply a little extra side force to get it to seat properly. I put in the new RAM and just got a beeping sound upon starting. I then put the old RAM back in and got the same result.

Here is the solution I found on the Apple discussion board.

"Take a small flat head screwdriver and after you put the memory in slot 0, put the screwdriver between the top of the mac mini and the memory then turn the screwdriver a little to exert pressure on the memory into the slot. Do it on both sides of the memory."

This worked for me.

littlemas2 - 답글

I remember this when I was changing my memory ... I realized (after opening) that more you push, more force it take to open the cover. As you push down you force the cover "to rub" the casing and possibly other things inside. If you "lightly" hold the cover it comes right off ... Remember: less is more! :-)

Have fun!

Radek - 답글

We found it hard to use the thumbs but if you put the casing on a carpet and one person is holding the case while the other is using his palm of one hand to turn the cover it comes off quite smoothly and without much downward pressure.

Alexander - 답글

Use your whole palm to twist it, with maybe a thumb in one of the recesses, applying slight downward pressure. Thewatchseries

mariya dems - 답글

Tilt the mini enough to allow the bottom cover to fall away from the outer case.
  • Tilt the mini enough to allow the bottom cover to fall away from the outer case.

  • Remove the bottom cover and set it aside.

I have a late 2012 Mac mini, but it must be an earlier version than this late 2012 Mac mini in this description, because removing the hard drive is much more complicated than described here. Please see this YouTube video if you have trouble removing your hard drive with these directions. https://www.youtube.com/watch?v=cvmuQIZP... There is a longer process you've got to go through. It can be done, it just takes much longer. (3-4 hours for me)

sandyfacebook - 답글

This applied to me as well. The iFixit article was good and lots of helpful information in the comments but my mini was different and required more dismantling. The video sandyfacebook posted was very helpful in taking me the rest of the way. https://www.youtube.com/watch?v=cvmuQIZP...

Erik Heerlein -

My HDD replacement procedure took 2 jours of research, one night sleeping on it and 30 minutes to perform…

Rene Girardin - 답글

결승점

다른 14명이 해당 안내서를 완성하였습니다.

Walter Galan

561,620 평판

안내서 1,203개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 9

지난 30일: 34

전체 시간: 21,382