기기를 수리하세요 커뮤니티 상점

MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

소개

Internal Prereq.

필요한 것

  1. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement, Optical Drive: 1 단계, 이미지 1/1

    • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up from its socket on the logic board.

    번역하기

  2. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 2 단계, 이미지 1/1

    • Carefully pull the camera cable out of its socket on the logic board.

    • Though not recommended by iFixit staff, some users opt to omit this step completely. For information on this, see the step comments.

    • Pull the cable parallel to the face of the logic board. Pulling it upward may damage the logic board or the cable itself.

    번역하기

  3. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 3 단계, 이미지 1/2 MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 3 단계, 이미지 2/2

    • Carefully move the AirPort/Bluetooth ribbon cable out of the way as you peel the camera cable off the adhesive securing it to the subwoofer and the AirPort/Bluetooth bracket.

    • De-route the camera cable out from under the retaining finger molded into the AirPort/Bluetooth bracket.

    번역하기

  4. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 4 단계, 이미지 1/2 MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 4 단계, 이미지 2/2

    • Use the tip of a spudger to pry the antenna connector closest to the logic board up from its socket on the AirPort/Bluetooth board.

    • De-route the antenna cable from under the finger molded into the AirPort/Bluetooth bracket.

    번역하기

  6. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 5 단계, 이미지 1/1

    • Remove the following five screws:

    • Two 10.3 mm Phillips screws

    • Two 3.1 mm Phillips screws

    • One 5 mm Phillips screw

    번역하기

  7. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 6 단계, 이미지 1/2 MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 6 단계, 이미지 2/2

    • Pull the AirPort/Bluetooth assembly and the Subwoofer upward near the center of the side of the optical drive until they clear each other.

    • Move the AirPort/Bluetooth assembly and the subwoofer away from the top of the optical drive.

    번역하기

  8. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 7 단계, 이미지 1/2 MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 7 단계, 이미지 2/2

    • Pull the right speaker/subwoofer cable out from under the retaining finger near the side of the optical drive.

    • Pull the right speaker/subwoofer cable upward to disconnect it from the logic board.

    번역하기

  9. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 8 단계, 이미지 1/1

    • Use the flat end of a spudger to pry the hard drive cable connector up from its socket on the logic board.

    • Bend the hard drive cable away from the optical drive.

    번역하기

  10. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 9 단계, 이미지 1/1

    • Use the flat end of a spudger to pry the optical drive connector up from its socket on the logic board.

    번역하기

  11. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 10 단계, 이미지 1/1

    • Remove the three 2.7 mm Phillips screws securing the optical drive to the upper case.

    번역하기

  12. MacBook Pro 13" Unibody Early 2011 Optical Drive Replacement: 11 단계, 이미지 1/1

    • Pull the optical drive upward from its edge closest to the display and remove it from the upper case.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 8명과 함께

Andrew Bookholt

586,200 평판

안내서 619개 작성하였습니다

배지: 47

배지 +44개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 717