주요 콘텐츠로 건너뛰기

소개

Upgrade the RAM in your Mid 2012 MacBook Pro 13" Unibody.

  1. Remove the following ten screws:
    • Remove the following ten screws:

    • Three 14.4 mm Phillips #00 screws

    • Three 3.5 mm Phillips #00 screws

    • Four 3.5 mm shouldered Phillips #00 screws

    • When replacing the small screws, align them perpendicular to the slight curvature of the case (they don't go straight down).

  2. Use your fingers to pry the lower case away from the body of the MacBook near the vent. Remove the lower case.
    • Use your fingers to pry the lower case away from the body of the MacBook near the vent.

    • Remove the lower case.

  3. Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board. It is useful to pry upward on both short sides of the connector to "walk" it out of its socket. Be careful with the corners of the connectors, they can be easily broken off.
    • Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.

    • It is useful to pry upward on both short sides of the connector to "walk" it out of its socket. Be careful with the corners of the connectors, they can be easily broken off.

  4. Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.
    • Bend the battery cable slightly away from its socket on the logic board so it does not accidentally connect itself while you work.

  5. Pull the two RAM retaining arms away from the center of the RAM chip. The RAM chip should "pop" up slightly from its socket.
    • Pull the two RAM retaining arms away from the center of the RAM chip.

    • The RAM chip should "pop" up slightly from its socket.

  6. Pull the RAM stick out of its socket.
    • Pull the RAM stick out of its socket.

    • Repeat this process to remove the second RAM chip.

결론

To reassemble your device, follow these instructions in reverse order.

다른 417명이 해당 안내서를 완성하였습니다.

Andrew Optimus Goldheart

회원 가입일: 2009년 10월 17일

425,980 평판

안내서 411개 작성하였습니다

iFixit iFixit 회원

Community

104 회원들

안내서 9,251개 작성하였습니다

My mid-2012 2.5 i5 works perfectly with 16 Gb of 1600Mhz DDR3.

nix - 답글

Just replaced my 4GB with 16GB of PNY from Best Buy. AWESOME difference in performance!!

Michael Chandler -

Could you please specify the memory chip that you bought? I need more details in order to get the right one, thanks!

Lin -

Any memory kit that is either validated by Apple or that has the proper channel configuration (9-9-9-24) is okay to use. If you are looking for pure performance RAM, a kit of Corsair Vengeance RAM is okay to use (again, check the channel configuration), but most people will benefit from a kit of Corsair Mac Memory or the kit that iFixit provides in the volume of your choice.

Seji the veggie -

Please note that the Apple says that this MacBook pro is using 1600MHz DDR3 memory. Instructons suggestinf an old memory for some reason.

http://www.apple.com/macbook-pro/specs/

Serhiy - 답글

댓글 쓰기

조회 통계:

지난 24시간: 78

지난 7일: 559

지난 30일: 2,440

전체 시간: 308,930