이 버전에는 잘못된 편집 사항이 있을 수 있습니다. 최신 확인된 스냅샷으로 전환하십시오.
필요한 것
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Peel away any stickers from the backside of the rear case covering the feet you have chosen to replace.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove any broken or damaged feet.
-
If the old foot is difficult to remove, use a hair dryer or a heat gun to apply some heat to the area and loosen the adhesive.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Scrub the foot cavity with adhesive remover to remove any remaining adhesive.
-
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Wipe the foot cavity with an isopropyl alcohol prep pad to remove any cleaner residue and prep the area for the adhesive on the new foot.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Align the new foot inside the cavity.
-
Lay the foot down while keeping it properly aligned.
-
Check for proper alignment from the inside of the case. The alignment nub should be slightly visible through the alignment hole.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Press the new foot into place firmly with your finger, then apply pressure by pinching the foot from either side of the case with your finger and your thumb.
-
Maintain pressure for 30 seconds to set the pressure-sensitive adhesive.
-
Repeat the last seven steps for any remaining broken or worn feet.
-
다른 3명이 해당 안내서를 완성하였습니다.