기기를 수리하세요

수리할 권리

상점

MacBook Unibody Model A1342 LCD Replacement

작성자 Andrew Bookholt (또 다른 기여자 4명)
  • 댓글 1
  • 즐겨찾기 0

난이도

보통

단계

4

소요 시간

시간 제안??

섹션

1

플래그

1

Prerequisite Only

단지 전제 조건

해당 안내서는 단지 다른 안내서의 전제 조건임을 참고하시기 바랍니다.

소개

This guide is an internal prerequisite.

도구

해당 도구 구매

부품

지정된 부품이 없습니다.

  1. Remove following six screws securing the LCD to the rear display bezel:

    • Remove following six screws securing the LCD to the rear display bezel:

    • Four 3.4 mm Phillips.

    • Two 3 mm Phillips.

    편집

  2. Do not try to remove the LCD yet. The circuitry along its lower edge is wedged in a gap along the lower edge of the display recess in the plastic display assembly.

    • Do not try to remove the LCD yet. The circuitry along its lower edge is wedged in a gap along the lower edge of the display recess in the plastic display assembly.

    • Hold the display vertically and tip it enough to grab the top edge of the LCD and rotate it slightly out of the display assembly, being careful not to break the circuitry off its lower edge.

    편집

  4. Peel the piece of tape covering the display data cable connector away from the edge closest to the LCD.

    • Peel the piece of tape covering the display data cable connector away from the edge closest to the LCD.

    편집

  5. Use the tip of a spudger to flip up the thin steel retaining clip securing the display data cable to its socket on the LCD. Pull the display data cable straight away from its socket on the LCD.

    • Use the tip of a spudger to flip up the thin steel retaining clip securing the display data cable to its socket on the LCD.

    • Pull the display data cable straight away from its socket on the LCD.

    • Lift the LCD out of the display assembly and set it aside.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Andrew Bookholt

555,111 평판

안내서 618개 작성하였습니다

배지: 47

배지 +44개 더

댓글 0개

의견 추가하세요

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 773