소개

Use this as a guide to remove or replace the controller's face buttons and shoulder buttons.

Use tweezers to completely remove the sticker from the rear of controller.
  • Use tweezers to completely remove the sticker from the rear of controller.

댓글 쓰기

Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.
  • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

댓글 쓰기

  • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

  • Use the plastic opening tool to pry the two cases apart.

댓글 쓰기

  • Remove the two rubber side grips.

댓글 쓰기

  • Locate RS-DP-LS switch.

  • Pull upwards on the switch to remove it.

댓글 쓰기

  • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

댓글 쓰기

  • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

  • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

  • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

댓글 쓰기

  • Remove the six buttons one by one by gripping the back of each one and pushing on them from the front.

  • Use tweezers to remove the rubber part of the directional pad before you try to remove the shoulder buttons.

  • When reinserting the buttons make sure they are in the correct place and oriented correctly.

댓글 쓰기

  • Remove the left and right shoulder buttons by sliding them out of their respective slots.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Eric

회원 가입일: 2012년 09월 26일

81 평판

안내서 3개 작성하였습니다

Cal Poly, Team 1-7, Propen Fall 2012 Cal Poly, Team 1-7, Propen Fall 2012 회원

CPSU-PROPEN-F12S1G7

4 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 2

지난 30일: 13

전체 시간: 1,907