소개

A quick guide to accessing the RoadMate's logic board.

부품

부품은 필요하지 않습니다.

Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.
  • Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.

  • Please note: this is a tedious process, but be patient.

댓글 쓰기

Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.
  • Remove the 4 screws holding the cover in place using a Philips #00 screwdriver.

댓글 쓰기

  • Open the back cover.

  • Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.

댓글 쓰기

  • Disconnect the speaker from the terminal.

  • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

In my 1200, the speaker is glued to the back and soldered into the board so there is no plug to undo. Just carefully find a position so that board doesn't pull on the speaker wire while it is open.

Jomar - 답글

where can we get the speakers from? please

bbunni1404 - 답글

  • Unscrew the 2 screws on either side of the board.

For me, there were two screws, just located at the corners. One was near where the speaker is soldered to the board and the other was diagonally across the board where the GPS unit is soldered into the board.

Jomar - 답글

  • Lift the circuit board up and disconnect the GPS connector.

My GPS unit, as mentioned, is soldered into the board, so no conector to remove. The GPS unit lifted right out with the board and was not attached to the display at all.

Jomar - 답글

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Ross Light

회원 가입일: 2010년 04월 12일

175 평판

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 1

전체 시간: 4,805