소개

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

  1. Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver. Screw length is 16 mm.
    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

  2. Remove the top of the boat by sliding it backwards and then pulling it off. Remove the top of the boat by sliding it backwards and then pulling it off. Remove the top of the boat by sliding it backwards and then pulling it off.
    • Remove the top of the boat by sliding it backwards and then pulling it off.

  3. US$100 이상 또는 Pro Tech Toolkit을 포함한 모든 주문의 배송은 무료입니다!

    상점 둘러보기
  4. Grab the rubber gasket with tweezers and pull it out of the slot. Grab the rubber gasket with tweezers and pull it out of the slot.
    • Grab the rubber gasket with tweezers and pull it out of the slot.

  5. Gently remove the gasket and replace with a new one. Gently remove the gasket and replace with a new one. Gently remove the gasket and replace with a new one.
    • Gently remove the gasket and replace with a new one.

결론

To reassemble your device, follow these instructions in reverse order.

Monica Reece

회원 가입일: 2018년 08월 31일

651 평판

안내서 5개 작성하였습니다

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 52