주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

In the event that the buttons on the side of the Microsoft Band 2 become jammed or unresponsive, follow this guide to learn how to remove them for cleaning or replacement.

  1. Wear proper gloves when using a heatgun.
    • Wear proper gloves when using a heatgun.

    • Use a heatgun to melt the adhesive beneath the screen. Heat the metal around edges of the screen.

    • Avoid heating the rubber watch band as it will quickly melt.

    • Heating the LCD screen may damage it. Avoid this procedure unless you intend to replace the screen.

  2. Manta(만타) 드라이버 키트

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta(만타) 드라이버 키트

    Upgrade Your Toolbox
  3. Use metal tweezers to gently detach the orange press-fit (or "pop") connector. Use metal tweezers to gently detach the orange press-fit (or "pop") connector.
    • Use metal tweezers to gently detach the orange press-fit (or "pop") connector.

  4. Use the T3 Torx Screwdriver to remove the two 2.7 mm screws
    • Use the T3 Torx Screwdriver to remove the two 2.7 mm screws

  5. Lift the logic board and locate the two circular clips securing the buttons from inside the wall of the Band 2. Remove them by sliding the clips sideways.
    • Lift the logic board and locate the two circular clips securing the buttons from inside the wall of the Band 2. Remove them by sliding the clips sideways.

  6. Remove the buttons, being careful not to lose the springs.
    • Remove the buttons, being careful not to lose the springs.

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Chris Syracuse

회원 가입일: 2017년 02월 20일

637 평판

안내서 3개 작성하였습니다

USF Tampa, Team S1-G5, Leahy Spring 2017 USF Tampa, Team S1-G5, Leahy Spring 2017 회원

USFT-LEAHY-S17S1G5

3 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 2

7일 전: 2

30일 전: 4

전체 시간: 1,106