Milwaukee 2704-20 Trigger Replacement

소개

Is your drill not functioning properly, specifically when it comes to pulling the trigger? If so, this guide will help you remove and replace your current faulty trigger mechanism. This guide strictly covers replacement of the trigger assembly only. For a full drill disassembly breakdown, refer to this guide.

필요한 것

1 단계 Outer Case

Milwaukee 2704-20 Trigger Replacement, Outer Case: 1 단계, 이미지 1/2

Milwaukee 2704-20 Trigger Replacement, Outer Case: 1 단계, 이미지 2/2

Remove the battery from the drill.

편집

2 단계

Milwaukee 2704-20 Trigger Replacement: 2 단계, 이미지 3/3

Remove the indicated screws (M3 x 16mm Pan Hd. ST T-10 Screws) with screwdriver.

편집

3 단계

Milwaukee 2704-20 Trigger Replacement: 3 단계, 이미지 3/3

Gently lift the cover off the drill. Be careful not to force it or damage any of the internal components.
If the cover doesn't come off easily, check for any clips or latches that may be holding it in place. These can usually be released by pressing them with a small flathead screwdriver.

편집

4 단계 Trigger

Milwaukee 2704-20 Trigger Replacement, Trigger: 4 단계, 이미지 1/2

Milwaukee 2704-20 Trigger Replacement, Trigger: 4 단계, 이미지 2/2

Desolder the two solder joints on the trigger assembly.
USE CAUTION! Soldering irons get extremely hot, as will everything they make prolonged contact with.