소개

The flashbulb and casing are one component located at the top of the camera. A replacement will be the whole component and not each of the parts separately.

부품

부품은 필요하지 않습니다.

Locate and remove the silver screws on each side of the camera. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.
  • Locate and remove the silver screws on each side of the camera.

  • Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

댓글 쓰기

Then, carefully pry apart the front and back outer casing away from the internal components. Be aware of the ribbon wire that will disconnect when the casing is detached. Be aware of the ribbon wire that will disconnect when the casing is detached.
  • Then, carefully pry apart the front and back outer casing away from the internal components.

  • Be aware of the ribbon wire that will disconnect when the casing is detached.

댓글 쓰기

Mac RAM 키트
Mac 속도를 높이십시오. 메모리를 최대한 활용하십시오.
Mac RAM 키트
Mac에서 메모리를 더 많이 확보하십시오.
Remove 2mm screws connecting the flash housing to the main components of the camera. Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .
  • Remove 2mm screws connecting the flash housing to the main components of the camera.

  • Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .

댓글 쓰기

Use the spudger to push the black plastic hooks through the circuit board to release the flash housing. Once the screws have been removed, pull the circuit board away from the body of the camera. Wires will keep it from completely detaching.
  • Use the spudger to push the black plastic hooks through the circuit board to release the flash housing.

  • Once the screws have been removed, pull the circuit board away from the body of the camera.

  • Wires will keep it from completely detaching.

  • Pull the housing away from the circuit board.

댓글 쓰기

결론

To reassemble device, follow steps in reverse order. This will require the reattachment of wires from the camera to the flashbulb casing.

Keith Sechrist

회원 가입일: 2013년 03월 11일

22 평판

안내서 2개 작성하였습니다

Clemson, Team 12-4, Benson Spring 2013 Clemson, Team 12-4, Benson Spring 2013 회원

CLEM-BENSON-S13S12G4

3 회원들

안내서 7개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 1

전체 시간: 294