기기를 수리하세요 커뮤니티 상점

Minolta QTsi Maxxum View Finder Replacement

소개

Replace your viewfinder if it breaks so that you can see through the camera to take pictures.

필요한 것

  1. Minolta QTsi Maxxum View Finder Replacement, View Finder: 1 단계, 이미지 1/1

    • Locate the battery compartment on the bottom panel of camera.

    • Use a small coin to untwist and open the batter compartment door.

    • Twist the coin counterclockwise to unlock the battery compartment door.

    편집

  2. Minolta QTsi Maxxum View Finder Replacement: 2 단계, 이미지 1/1

    • Two batteries are located inside the battery compartment

    • Be careful, the batteries inside the compartment are small and easy to lose.

    • Remove the two batteries from inside the battery compartment by individually pulling each out.

    편집

  3. Minolta QTsi Maxxum View Finder Replacement: 3 단계, 이미지 1/1

    • When the batteries are removed from the compartment, one screw will be visible in the bottom of the chamber.

    • Unscrew the (1) black Phillips #00 5mm screw from the bottom of the battery chamber.

    • Be careful when unscrewing the screw because it's small and is easy to lose.

    편집

  5. Minolta QTsi Maxxum View Finder Replacement: 4 단계, 이미지 1/1

    • Remove the (2) black Phillips #00 5mm screws that lie on either side of the view finder.

    • Be careful because the two screws are small and are easy to lose.

    편집

  6. Minolta QTsi Maxxum View Finder Replacement: 5 단계, 이미지 1/1

    • Remove the (1) black Phillips #00 5mm screw from underneath the flash hood.

    • Be careful because the screw is small and is easy to lose.

    편집

  7. Minolta QTsi Maxxum View Finder Replacement: 6 단계, 이미지 1/2 Minolta QTsi Maxxum View Finder Replacement: 6 단계, 이미지 2/2

    • Once all screws are removed, the top of the camera should come off easily.

    • Be careful when removing the top, there are wires connected that could be damaged.

    편집

  8. Minolta QTsi Maxxum View Finder Replacement: 7 단계, 이미지 1/1

    • The viewfinder will fall when the screws are removed.

    • Remove the (2) black Phillips #00 5mm screws that hold the viewfinder.

    • Be careful because the screws are small and easy to lose.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Maya Van Londen

회원 가입일: 10/10/16

315 평판

안내서 2개 작성하였습니다

배지: 12

배지 +9개 더

팀

Sam Houston State, Team 12-4, Blackburne Fall 2016 Sam Houston State, Team 12-4, Blackburne Fall 2016 회원

SHSU-BLACKBURNE-F16S12G4

4 회원들

안내서 5개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 3

30일 전: 17

전체 시간: 814