기기를 수리하세요 커뮤니티 상점

Motorola Defy XT Camera Replacement

소개

This guide shows the steps necessary to remove and install an integrated camera in the Motorola Defy XT mobile phone.

The Motorola Defy XT model has been discontinued.

필요한 것

  1. Motorola Defy XT Camera Replacement, Camera: 1 단계, 이미지 1/1

    • Locate the opening on the corner of the Motorola Defy XT mobile phone.

    • Wedge the Plastic Opening Tool between the back cover and the body of the phone.

    번역하기

  2. Motorola Defy XT Camera Replacement: 2 단계, 이미지 1/1

    • Once wedged in the opening, gently pry around the phone until back cover lifts off.

    번역하기

  3. Motorola Defy XT Camera Replacement: 3 단계, 이미지 1/1

    • Remove the back cover and locate the battery.

    • Insert the opening tool beneath the battery and lightly push upward.

    번역하기

  4. Motorola Defy XT Camera Replacement: 4 단계, 이미지 1/1

    • Locate the SD card beneath the plastic cover in the corner.

    • Use a Plastic Opening Tool to hook the edge of the SD card

    번역하기

  6. Motorola Defy XT Camera Replacement: 5 단계, 이미지 1/1

    • Push the SD card straight out.

    번역하기

  7. Motorola Defy XT Camera Replacement: 6 단계, 이미지 1/1

    • Use the T4 Torque Driver to remove all 6 of the 3mm diameter screws on the outside edges of the phone.

    번역하기

  8. Motorola Defy XT Camera Replacement: 7 단계, 이미지 1/1

    • Wedge the Plastic Opening Tool under the inner side of the volume buttons.

    • Pop the volume buttons out of the phone.

    번역하기

  9. Motorola Defy XT Camera Replacement: 8 단계, 이미지 1/1

    • Locate the base of the motherboard.

    • Slide the Plastic Opening Tool along the base of the motherboard to separate it from the phone.

    • Gently guide the two pieces apart with upward motion.

    • Caution: Do not damage the ribbon that is holding both pieces

    번역하기

  10. Motorola Defy XT Camera Replacement: 9 단계, 이미지 1/1

    • Disconnect the ribbon from the frame.

    • Remove the screen.

    번역하기

  11. Motorola Defy XT Camera Replacement: 10 단계, 이미지 1/1

    • Flip the mother board over.

    • Locate the base of the ribbon cable.

    • Pull straight outward using the Plastic Opening Tool.

    • Disconnect the ribbon cable connecting the display to the logic board

    번역하기

  12. Motorola Defy XT Camera Replacement: 11 단계, 이미지 1/1

    • Pull the two halves of the device apart to disconnect the second (wider) ribbon connector.

    • Note: The ribbon connector is bonded to the logic board with adhesive, simply pull it to remove it completely.

    번역하기

  13. Motorola Defy XT Camera Replacement: 12 단계, 이미지 1/1

    • Flip the mother board over.

    • Use the Plastic Opening Tool to disconnect the camera from the logic board.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 6명과 함께

Mustapha Nadri

회원 가입일: 04/19/13

1 평판

안내서 1개 작성함

배지: 1

팀

Cal Poly, Team 2-22, Maness Spring 2013 Cal Poly, Team 2-22, Maness Spring 2013 회원

CPSU-MANESS-S13S2G22

3 회원들

안내서 8개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 2

30일 전: 13

전체 시간: 881