소개

If one needs access to the inner components of the Droid X or they are needing to replace the rear plastic of the device, this guide will walk a reader through the necessary steps.

부품

부품은 필요하지 않습니다.

Locate the power button at the top of the phone.  Depress power button for 2 seconds until a menu appears.
  • Locate the power button at the top of the phone. Depress power button for 2 seconds until a menu appears.

댓글 쓰기

Once the menu appears, select the "power off" option.  Wait until the phone is completely off.
  • Once the menu appears, select the "power off" option. Wait until the phone is completely off.

댓글 쓰기

  • Place thumb on the back cover, and push down towards the bottom of the device. Once the cover releases, pull it away from the phone and set it aside.

댓글 쓰기

  • Find the yellow pull tab located in the upper left corner. Pull the tab until the battery dislodges. Grab the battery by the raised edge, and remove it from the case.

댓글 쓰기

  • The battery has been successfully removed.

댓글 쓰기

  • Remove the micro SD card from its connector.

댓글 쓰기

  • Locate the seam between the back case and the end cover on the top edge of the phone.

  • Use the plastic opening tool to detach the two clips by wedging the tool into the right side of the seam and moving right to left. Once the cover comes off set it aside

댓글 쓰기

  • Repeat step 2 on the bottom cover.

댓글 쓰기

  • Use a T5 Torx screwdriver to remove the screws in each corner of the phone.

  • The screws are very small so make sure not to lose them.

댓글 쓰기

  • Flip the phone over and locate the screw on the middle of the left side. Unscrew it using the T5 Torx screwdriver and set it aside.

댓글 쓰기

  • Identify the screw located in the bottom right corner of the battery case. Remove the screw with a T5 (or in some cases T6) torx screwdriver and set it aside.

댓글 쓰기

  • Locate the seam along the right edge of the phone. Use the prying tool to disconnect the two clips along the edge.

댓글 쓰기

  • Locate the two clips on the inside of the case and use the spudger tool to detach them from the case. To detach each clip, use the sharp end to press the small, black plastic in the center of the clip.

댓글 쓰기

  • After the clips are detached, remove the back case and set it aside.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 한 분이 해당 안내서를 완성하였습니다.

Sam Johnston

회원 가입일: 2012년 10월 03일

464 평판

안내서 4개 작성하였습니다

Cal Poly, Team 18-40, Regan Fall 2012 Cal Poly, Team 18-40, Regan Fall 2012 회원

CPSU-REGAN-F12S18G40

3 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 1

지난 7일: 2

지난 30일: 5

전체 시간: 716