기기를 수리하세요 커뮤니티 상점

Motorola MBP33SBU Baby Unit Speaker Replacement

소개

The Baby Unit Speaker allows sound between the two units. You will need a soldering kit to successfully install a new speaker.

필요한 것

  1. Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: 1 단계, 이미지 1/3 Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: 1 단계, 이미지 2/3 Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: 1 단계, 이미지 3/3

    • Using precision tweezers, remove the (4) four rubber feet from the bottom of the baby unit.

    • Using a Phillips #1 screwdriver remove the 9.5mm screws that were under the rubber feet.

    • Open the base of the baby unit.

    편집

  3. Motorola MBP33SBU Baby Unit Speaker Replacement: 2 단계, 이미지 1/3 Motorola MBP33SBU Baby Unit Speaker Replacement: 2 단계, 이미지 2/3 Motorola MBP33SBU Baby Unit Speaker Replacement: 2 단계, 이미지 3/3

    • Using the Phillips #1 screwdriver remove the 9.5mm washer head screws holding the speaker in place.

    • Gently lift the speaker by the wires from its plastic base.

    편집

  4. Motorola MBP33SBU Baby Unit Speaker Replacement: 3 단계, 이미지 1/2 Motorola MBP33SBU Baby Unit Speaker Replacement: 3 단계, 이미지 2/2

    • Desolder the wires connecting the speaker to the circuit board.

    • Beware of overheating, the soldering kit is capable of damaging the circuit board.

    • Beware of the potential for personal injury from heated metals.

    • For soldering procedures please refer to iFixit's guide to Soldering Skills.

    편집
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 3명과 함께

Ely Tilley

회원 가입일: 09/28/17

714 평판

안내서 5개 작성하였습니다

배지: 8

배지 +5개 더

팀

Eastern Washington University, Team S2-G5, Crane Fall 2017 Eastern Washington University, Team S2-G5, Crane Fall 2017 회원

EWU-CRANE-F17S2G5

4 회원들

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 4

7일 전: 4

30일 전: 10

전체 시간: 1,927