기기를 수리하세요 커뮤니티 상점

Motorola Moto Q Back Casing Replacement

소개

This guide will show you step-by-step how to replace the back casing.

필요한 것

  1. Motorola Moto Q Back Casing Replacement, Back Casing: 1 단계, 이미지 1/1

    • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

    • Be careful not to poke yourself when handling the push pin because it is very sharp.

    번역하기

  2. Motorola Moto Q Back Casing Replacement: 2 단계, 이미지 1/1

    • Use the T6 screwdriver to remove the four screws holding the casing together.

    • Note: they are in the same place where you removed the four rubber coverings

    번역하기

  4. Motorola Moto Q Back Casing Replacement: 3 단계, 이미지 1/2 Motorola Moto Q Back Casing Replacement: 3 단계, 이미지 2/2

    • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

    • Note: the phone should be face up and the plastic opening tool should be face downwards

    • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

    • Repeat the 3 steps above for the top, bottom, and opposite side.

    번역하기

  5. Motorola Moto Q Back Casing Replacement: 4 단계, 이미지 1/2 Motorola Moto Q Back Casing Replacement: 4 단계, 이미지 2/2

    • Gently lift and remove the back casing.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 6명과 함께

Luis Herrera

회원 가입일: 01/21/10

52 평판

안내서 4개 작성하였습니다

배지: 12

배지 +9개 더

팀

Cal Poly, Team 16-33, Maness Winter 2010 Cal Poly, Team 16-33, Maness Winter 2010 회원

CPSU-MANESS-W10S16G33

4 회원들

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 5,143