소개

This guide is for removing the phone's earpiece speaker.

부품

부품은 필요하지 않습니다.

  1. Using a spudger, remove the four rubber covers from over the screws.
    • Using a spudger, remove the four rubber covers from over the screws.

    댓글 쓰기

  2. Unscrew the cover screws using the T6 bit
    • Unscrew the cover screws using the T6 bit

    댓글 쓰기

    • Loosen and remove the cover with a plastic opening tool.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Gently loosen the protective cover with the plastic opening tool.

    Do not pry from the top or bottom of the metal cover. There are a pair of 1/4" long openings on either side of the metal cover at the midpoint of the case. The plastic teeth which lock into the openings must be withdrawn. I used the point of cuticle sissors to get behind the metal strip under each tooth and pull outwards a small distance to release each tooth. The sides of the cover will spring up.

    Fonce - 답글

    • Carefully remove the protective cover from the circuitry

    • Slowly peel the black rubber gasket up off the circuit board.

    • Carefully move the camera out of the way using your hand.

    • Use a flat tool to separate the connection between the upper and lower circuit boards.

    댓글 쓰기

    • Gently slip the copper strip out from under the circutry by hand.

    댓글 쓰기

    • Pry out the speaker using your fingers.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

gregatron

회원 가입일: 2009년 10월 29일

72 평판

안내서 6개 작성하였습니다

Cal Poly, Team 6-6, Maness Fall 2009 Cal Poly, Team 6-6, Maness Fall 2009 회원

CPSU-MANESS-F09S6G6

4 회원들

안내서 12개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 2

전체 시간: 2,586