소개

This guide describes how to replace the button key board, or the processor that interprets key pad information.

Remove battery cover by pushing down release lever at top of phone while prying off cover.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

댓글 쓰기

Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

댓글 쓰기

  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

댓글 쓰기

  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

댓글 쓰기

  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

댓글 쓰기

  • Gently remove orange ribbon cable by prying up with spudger.

댓글 쓰기

  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

댓글 쓰기

  • Insert spudger under button board and gently lift, set aside.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

회원 가입일: 2010년 01월 26일

1 평판

안내서 7개 작성하였습니다

Cal Poly, Team 8-48, Regan Winter 2010 Cal Poly, Team 8-48, Regan Winter 2010 회원

CPSU-REGAN-W10S8G48

4 회원들

안내서 13개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 0

전체 시간: 1,278