Motorola Xoom 2 Rear-Facing Camera Replacement

소개

Overtime, the camera of a device may be subject to fail. Common troubleshooting symptoms of a failing camera can include (and are not limited to): device isn’t taking photos, camera shows black, camera won’t turn on, etc.

This replacement guide demonstrates the steps required to replace a cracked, damaged, or otherwise inoperable rear-facing camera on the Xoom 2.

필요한 것

1 단계 Backplate

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 1 단계, 이미지 1/3

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 1 단계, 이미지 2/3

Motorola Xoom 2 Rear-Facing Camera Replacement, Backplate: 1 단계, 이미지 3/3

Pry off the silver top back cover (the panel around the camera) with iFixit opening picks or a similar implement.

편집

2 단계

Using a T5 screwdriver, unscrew the four 1.5mm screws holding the main back cover. These screws are arranged in a line across the top of the back of the device.

편집

3 단계

Motorola Xoom 2 Rear-Facing Camera Replacement: 3 단계, 이미지 3/3

Turn the device over and using a pry tool and the opening picks, gently apply pressure between the outside edge of the seal marked with the arrow. Slowly move around the edges of the device, applying even pressure, and separate the back plate from the display.
There is adhesive between the back-plate and battery.

편집

4 단계

Remove the back plate from your device.

편집

5 단계 Rear-Facing Camera

Motorola Xoom 2 Rear-Facing Camera Replacement, Rear-Facing Camera: 5 단계, 이미지 1/1

Using tweezers, remove the blue Kapton tape.
Set this piece aside as it is required for reassembly.

편집

6 단계

Using a spudger, carefully pry and remove camera assembly using the small pry point as shown.
After removing the camera from the housing, use tweezers and pull gently to remove the connector from its housing.

편집