주요 콘텐츠로 건너뛰기

소개

This guide outlines how to replace an LCD screen on the Moultrie I45 GameSpy camera

부품

지정된 부품이 없습니다.

  1. Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.
    • Using a Philips head screwdriver, remove the eight 6mm screws located at the bottom of the device.

    make sure to add commas.

    Step 1- remove the 8, 6mm...

    Step 2- Using a philips head screwdriver, remove the 6, 4mm screws...

    Same thing with step 6. Good page!

    Jesica Bartell - 답글

  2. Remove the butterfly nut from the lid arm.
    • Remove the butterfly nut from the lid arm.

  3. Remove the lid-covering.
    • Remove the lid-covering.

  4. Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.
    • Using a Phillips head screwdriver, remove the six 4mm screws from the face of the camera.

  5. Gently separate the two halves of the case.
    • Gently separate the two halves of the case.

    • The two halves are connected by a wire. Pulling too roughly can damage the wires and cause the camera to stop functioning.

  6. Using a Philips head screwdriver, remove the 12, 3mm screws from the board.
    • Using a Philips head screwdriver, remove the 12, 3mm screws from the board.

  7. Gently remove the circuit board from the face of the camera
    • Gently remove the circuit board from the face of the camera

    Mention the two pieces (black piece) of the LCD screen that you need to remove

    Jesica Bartell - 답글

  8. Remove the LCD screen.
    • Remove the LCD screen.

결론

To reassemble your device, follow these instructions in reverse order.

Sean Hill

회원 가입일: 2015년 01월 29일

434 평판

안내서 4개 작성하였습니다

UW Tacoma, Team 3-7, Rose Winter 2015 UW Tacoma, Team 3-7, Rose Winter 2015 회원

UWT-ROSE-W15S3G7

3 회원들

안내서 4개 작성하였습니다

where do you get the new LCD screen?

jeingram - 답글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 3

전체 시간: 482