Neato Botvac D8000 Top Face Panel Replacement

소개

These step-by-step instructions are provided so you can remove the top cover of the robot. This can be done as a step to remove the wheel or check the wiring.

필요한 것

1 단계 Top Face Panel

Neato Botvac D8000 Top Face Panel Replacement, Top Face Panel: 1 단계, 이미지 1/1

Grab the rear bumper with both hands on either side.

편집

2 단계

Firmly pull the bumper forward at a steady pace.
When pulling the bumper forward avoid being too rough because the bumper might break.

편집

3 단계

Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

편집

4 단계

Neato Botvac D8000 Top Face Panel Replacement: 4 단계, 이미지 3/3

Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

편집

5 단계

Neato Botvac D8000 Top Face Panel Replacement: 5 단계, 이미지 3/3

Push the clips, located in the back side, inward.
Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.
When you lift the top cover be careful because the wires are thin and fragile.