Neato XV Signature Motor Assembly Replacement

소개

In this guide, you will learn the necessary steps to replace the motor assembly of a Neato XV Signature vacuuming robot. This is a fairly simple fix, that only requires a few tools and should not take very long. Make sure the device is completely shut down before beginning.

필요한 것

1 단계 Motor Assembly

Neato XV Signature Motor Assembly Replacement, Motor Assembly: 1 단계, 이미지 1/2

Neato XV Signature Motor Assembly Replacement, Motor Assembly: 1 단계, 이미지 2/2

Flip your Neato XV Signature robot over so that so are looking at the underside of it.

번역하기

2 단계

Using a Phillips head #2 screwdriver, unscrew the four 14 mm (1.4 cm) screws on the external panel that covers the motor assembly.
Be sure not to lose the screws.

번역하기

3 단계

Use plastic spudger to gently pry off the external panel to expose the motor assembly.

번역하기

4 단계

Gently lift the motor assembly straight up, out of place, being aware of the four mounting posts that hold the motor firmly in place.

번역하기

5 단계

Neato XV Signature Motor Assembly Replacement: 5 단계, 이미지 3/3

Press the tab and gently lift straight up to disconnect the motor wires.

번역하기

6 단계

Neato XV Signature Motor Assembly Replacement: 6 단계, 이미지 3/3

After disconnecting the wire clip, remove the motor assembly out of the compartment.
With the replacement motor, you can now begin reassembly.

번역하기

결론

To finish connecting the new motor assembly, follow these steps in reverse order. Be sure to replace the back external panel and four screws to tightly secure.