이 버전에는 잘못된 편집 사항이 있을 수 있습니다. 최신 확인된 스냅샷으로 전환하십시오.
필요한 것
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the two 9.0 mm Phillips screws securing the battery compartment.
-
Slide the battery compartment out.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the single 11.0 mm Phillips screw securing the magazine cartridge chambers.
-
Pull the entire chamber upwards to separate it from the rest of the Nerf Gun.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove both halves of the ring by tugging on it upwards until the lock gets freed.
-
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the four 9.0 mm Phillips screws from the newly revealed cylinder.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the three 9.0 mm Phillips screws holding the top latch of the Nerf Gun together.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the three 9.0 mm Phillips screws holding together the firing chamber.
-
Remove the single 7.0 mm Phillips screw below the barrel.
-
Remove the two 14.0 mm Philips screws using a screwdriver with a length of approximately 4.0 inches and a diameter of approximately 0.2 cm.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the single 14.0 mm Phillips screw holding together the handle and the Nerf Gun.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Remove the two 9.0 mm Phillips screws holding together the handle.
-
Remove the plastic cover of the handle.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Insert one plastic opening tool inside one side of the orange part depicted in the picture.
-
Insert a second plastic opening tool to the other side of the orange part and gradually pull the piece out, freeing it from the handle.
-
-
이 단계는 번역되지 않았습니다. 번역을 도와주십시오
-
Pull one end of the handle away from the orange latch.
-
Repeat the procedure on the other side to completely remove the handle from the rest of the Nerf Gun.
-
다른 한 분이 해당 안내서를 완성하였습니다.