Nerf N-Strike Firestrike O-Ring and Plunger Replacement

소개

If the blaster doesn't cock properly, the plunger and O-ring assembly may be damaged or broken. In this guide, you will learn how to replace the O-Ring and Plunger from the Nerf N-Strike Firestrike. This requires nothing more than a number 1 Philips screwdriver.

필요한 것

1 단계 Remove battery cover

Nerf N-Strike Firestrike O-Ring and Plunger Replacement, Remove battery cover: 1 단계, 이미지 1/1

Use a #1 Phillips screwdriver to remove the 10 -mm screw that secures the battery plate, then remove the battery cover using your hands.

번역하기

2 단계

Slide out the two AAA batteries using your fingers.

번역하기

3 단계 Blaster Casing

Nerf N-Strike Firestrike O-Ring and Plunger Replacement, Blaster Casing: 3 단계, 이미지 1/1

Remove the seven 10-mm black Phillips screws from the blaster casing with a #1 Phillips Screwdriver.

번역하기

4 단계

Slowly pull apart the blaster casing, starting at the battery location.
Keep pulling apart slowly until it separates completely. Be cautious as to not send the internal components flying.

번역하기

5 단계

For reassembly, ensure that the chrome nut gets put back in the proper location, signified by the red box.
For reassembly, ensure that all the parts are lined up correctly on the dowels, signified by the four orange boxes.
For reassembly, note the location of the springs as highlighted in the second photo.