주요 콘텐츠로 건너뛰기
  1. Remove Micro SD card and Battery
    • Remove Micro SD card and Battery

  2. Remove 2 screws Open plastic LCD connector cover Lift FPC connector latch
    • Remove 2 screws

    • Open plastic LCD connector cover

    • Lift FPC connector latch

    • Detach LCD FPC

  3. Remove 4 screws Remove LCD module Remove LCD module
    • Remove 4 screws

    • Remove LCD module

  4. WARNING!!! DO NOT TOUCH THESE Solder joints!!! High Voltage up to 300V..
    • WARNING!!! DO NOT TOUCH THESE Solder joints!!! High Voltage up to 300V..

    • Or discharge the flash condenser first, as per "Main PCB replace guide"

    • Remove 3 screws

  5. Left side, in connector bay, remove 2 screws. Bottom, reomve 2 screws Right side, remove 1 screw
    • Left side, in connector bay, remove 2 screws.

    • Bottom, reomve 2 screws

    • Right side, remove 1 screw

  6. Peel here and remove 1 screw within.
    • Peel here and remove 1 screw within.

  7. Pop open back case and remove it from body. Pop open back case and remove it from body.
    • Pop open back case and remove it from body.

  8. Disconnect speaker Disconnect keypad FPC Disconnect keypad FPC
    • Disconnect speaker

    • Disconnect keypad FPC

  9. Push latches from below
    • Push latches from below

    • pop up and remove keypad.

결론

To reassemble your device, follow these instructions in reverse order.

Terrance

회원 가입일: 2009년 11월 17일

5,164 평판

안내서 10개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 24