난이도
쉬움
단계
6
소요 시간
5 분
- Back Cover 6 단계
일관성 없는 이미지
해당 안내서의 이미지를 전제 조건들과 더욱 일관성 있게 업데이트하는 것은 안내서의 멋짐이 향상될 것입니다.
소개
This guide is to be used to install the back cover in the event that it becomes damaged. A Phillips screwdriver will be needed to complete this installation.
부품
부품은 필요하지 않습니다.
-
Remove wrist strap by unknotting the strap.
-
Open SD/Battery cover.
-
Remove the four screws on the bottom of the camera using the Phillips-Head screwdriver.
-
Pull the silver side panels on each side.
-
On the right side of the camera (that contains the wrist strap loop), use the screwdriver to remove the two screws holding the backplate in place.
-
Repeat this step for the left side.
-
-
Pull the back silver faceplate to separate it from the rest of the camera.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
다른 한 분이 해당 안내서를 완성하였습니다.
팀
Clemson, Team 12-5, Benson Spring 2013 Clemson, Team 12-5, Benson Spring 2013 회원
CLEM-BENSON-S13S12G5
4 회원들
안내서 7개 작성하였습니다
