소개

You will need a #00 phillip's head screwdriver and a black spudger (or equivalent tool).

부품

부품은 필요하지 않습니다.

Turn over camera to find 5 apparent screws.
  • Turn over camera to find 5 apparent screws.

댓글 쓰기

Remove all 5 screws from the bottom of the camera and store them carefully.
  • Remove all 5 screws from the bottom of the camera and store them carefully.

댓글 쓰기

  • Open battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever. Remove this screw.

댓글 쓰기

  • Rotate camera to find side panel with lanyard attachment. Detach side panel by lifting bottom corner slightly with the spudger.

댓글 쓰기

  • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

댓글 쓰기

  • With back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

댓글 쓰기

  • Find the five screws on the metal plate and remove them. One of them is in a hole in the corner of the metal plate.

  • Also remove the screw at the bottom of the camera.

  • Carefully lift metal plate from the right side to reveal a ribbon connected to the motherboard.

댓글 쓰기

  • Lift the white flap with the spudger to release the ribbon and remove back metal plate.

댓글 쓰기

  • Lift the two ribbons with the spudger to disconnect the lens and pull it out.

댓글 쓰기

  • Lift two flaps with the spudger on the top of the motherboard to release ribbons.

댓글 쓰기

  • lift motherboard from the top to remove it from the camera.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

Ryan

회원 가입일: 2011년 04월 12일

131 평판

안내서 6개 작성하였습니다

Cal Poly, Team 18-24, Garner Spring 2011 Cal Poly, Team 18-24, Garner Spring 2011 회원

CPSU-GARNER-S11S18G24

4 회원들

안내서 6개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 0

지난 30일: 2

전체 시간: 1,491