Nikon D40 Back Cover Replacement

소개

This guide will demonstrate the proper procedure to remove the back panel without damaging the internals of the camera so that you can access a variety of the components hidden behind it.

필요한 것

1 단계 Back Cover

Nikon D40 Back Cover Replacement, Back Cover: 1 단계, 이미지 1/1

Remove the two visible 6.0 mm Philips #0 screws on the left and right sides of the viewfinder. These screws are highlighted in red.

번역하기

2 단계

Remove the four 6.0 mm Philips #0 screws on the left and right sides of the camera.

번역하기

3 단계

Remove the four highlighted 3.0 mm Philips #0 screws on the bottom of the camera.

번역하기

4 단계

While pulling the bottom down, remove the back of the camera.
Be careful not to pull too hard on the back as it is connected via a ribbon cable. Be sure to disconnect this cable on the main board.
To disconnect the ribbon cable pull the small black tab upward and pull gently on the cable.