주요 콘텐츠로 건너뛰기

Nikon D5000 Back Panel Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

필요한 것

  1. Nikon D5000 Back Panel Replacement, Back Panel: 1 단계, 이미지 1/3 Nikon D5000 Back Panel Replacement, Back Panel: 1 단계, 이미지 2/3 Nikon D5000 Back Panel Replacement, Back Panel: 1 단계, 이미지 3/3
    • The battery door has been removed for clarity, but is not necessary. See this guide for how to remove it.

    • Unscrew the eight Phillips #00 screws on the back panel:

    • Two 2.5x6mm screws above the screen.

    • One 3x6mm screw on the upper part of each side (two total; right side shown).

    • One 3x7.5mm screw on the lower part of each side (two total).

    • Two 3x4.5mm screws on the bottom.

  2. Nikon D5000 Back Panel Replacement: 2 단계, 이미지 1/3 Nikon D5000 Back Panel Replacement: 2 단계, 이미지 2/3 Nikon D5000 Back Panel Replacement: 2 단계, 이미지 3/3
    • Pull the back panel up, then tilt it back. There will be two cables still holding it on.

    • Doing this will also release the connector cover on the left side. Set it aside for now, but remember to reinstall it later.

    • Disconnect the ribbon cable by flipping the black tab up, then pulling the cable out.

    • This procedure also applies to all of the other ribbon cables in the D5000.

    • Pull out the other connector by lifting it up with tweezers, or by prying it out. Fingernails also work well.

결론

To reassemble your device, follow these instructions in reverse order.

Jacob Rardin

회원 가입일: 04/14/14

1,390 평판

안내서 6개 작성하였습니다

Cal Poly, Team 13-28, Maness Spring 2014 Cal Poly, Team 13-28, Maness Spring 2014 회원

CPSU-MANESS-S14S13G28

4 회원들

안내서 7개 작성하였습니다

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 0

전체 시간: 62