Skip to main content

소개

Replacing the board holding the GPS, DC in and AV out connectors.

Replacement of the electronic card including the GPS connector, DC IN, and AV out.

부품

No parts specified.

  1. Remove the three screw in red
    • Remove the three screw in red

    • Remove the three long screw in orange

    • Remove the screw in yellow

    • Use a little of WD40 if the screw is blocked

  2. Remove the 4 screw in green Remove the 2 screw in yellow Remove the 2 screw in yellow
    • Remove the 4 screw in green

    • Remove the 2 screw in yellow

  3. Slacken the grip side of the cover first Remove the cover wholly. Be carefull with the two flex cables
    • Slacken the grip side of the cover first

    • Remove the cover wholly.

    • Be carefull with the two flex cables

  4. Disconnect the FPC of the back cover Toggle up the black plate to free the flex cable Remove the grip cover by rotating
    • Disconnect the FPC of the back cover

    • Toggle up the black plate to free the flex cable

    • Remove the grip cover by rotating

  5. 맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now

    맥북 배터리 수리 키트

    기본 가격은 $69.99

    Buy Now
  6. Toggle up the black plate and disconnect the flex cable Toggle up the white plate and disconnect the flex cable Push up the right slide of the connector to free it
    • Toggle up the black plate and disconnect the flex cable

    • Toggle up the white plate and disconnect the flex cable

    • Push up the right slide of the connector to free it

  7. Push up the bottom of the connector to free it
    • Push up the bottom of the connector to free it

  8. Remove the six screws to free the protection plate Disconnect the white cables Disconnect the microphone Cable
    • Remove the six screws to free the protection plate

    • Disconnect the white cables

    • Disconnect the microphone Cable

  9. Disconnect the speaker cable Remove the two screws to free the PCB Toggle th PCB from Left to Right
    • Disconnect the speaker cable

    • Remove the two screws to free the PCB

    • Toggle th PCB from Left to Right

  10. Disconnect the black cables
    • Disconnect the black cables

  11. Remove the two screws Push the IF/SB PCB
    • Remove the two screws

    • Push the IF/SB PCB

    • Unsolder the 3 Wires ( Red, Black, Orange )

결론

To reassemble your device, follow the instructions in reverse order.

다음 번역가들에게 특별히 감사 드립니다:

100%

이 번역자 분들은 저희가 세상을 수리하는데 동참해 주시는 분입니다! 기여하시겠습니까?
번역 시작하기 ›

JOLY

회원 가입일: 2016년 03월 06일

182 평판

안내서 1개 작성함

Nexurium - Bastien JOLY Nexurium - Bastien JOLY 회원

Business

1 회원

안내서 2개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 2

지난 7일: 9

지난 30일: 36

전체 시간: 784