소개

The circuit board connects all the components within the controller and provides structural support for buttons, sticks, and chips.

부품

부품은 필요하지 않습니다.

Place the controller (buttons down) on a solid surface.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

댓글 쓰기

Gently lift the back panel up, separating it from the front panel.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

댓글 쓰기

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Grab the Z-button by the peg with tweezers and lift it out of the controller. During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.
  • Grab the Z-button by the peg with tweezers and lift it out of the controller.

  • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

댓글 쓰기

Carefully unhook the cable that is looped around the peg.
  • Carefully unhook the cable that is looped around the peg.

Um can soneone explain the peg and cable part? I dont understand it...

Tyler Goamez - 답글

I would say that the cable is somehow "hooked" to the case and you have to get the cable away from the case so that you can pull out the board

My1 -

Lift the circuit board out of the controller.
  • Lift the circuit board out of the controller.

    • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

다른 2명이 해당 안내서를 완성하였습니다.

Sean Michel

회원 가입일: 2013년 01월 14일

1,229 평판

안내서 14개 작성하였습니다

Cal Poly, Team 19-44, Regan Winter 2013 Cal Poly, Team 19-44, Regan Winter 2013 회원

CPSU-REGAN-W13S19G44

4 회원들

안내서 16개 작성하였습니다

this $@$* only shows how to disassemble the controller, this isnt a guide to even get the circuid board off the cable &&^&^$^ useless pieces of $@$* lmao

jmride - 답글

Yeah this isn't very in-depth, I was hoping for a little more. I need to desolder and rewire the buttons to use for another project and I was hoping this might be a nice guide to help me do that... it's not.

Joshua Arcari - 답글

댓글 쓰기

조회 통계:

지난 24시간: 6

지난 7일: 37

지난 30일: 109

전체 시간: 7,905