소개

This guide will help you remove the front panel of the controller. It is a prerequisite guide only.

부품

부품은 필요하지 않습니다.

  1. Pull down on the battery cover release lever and pull back to remove the cover.
    • Pull down on the battery cover release lever and pull back to remove the cover.

    댓글 쓰기

  2. Take out each battery then put the covering back on.
    • Take out each battery then put the covering back on.

    댓글 쓰기

  3. Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    Fixmas/픽스마스 분위기를 띄우세요
    FIXMAS12 코드로 $50 이상 구매시 $12 할인을 받으십시오
    • Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver.

    • During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.

    댓글 쓰기

    • After each screws has been removed carefully turn over the controller, and place on a flat surface.

    • Slowly separate the top panel from the bottom panel.

    • The buttons are loose and may fall off of the motherboard.

    • Once seperarted set aside the top panel.

    • During reassembly, make sure the front panel lines up with the buttons so they slide back into place.

    댓글 쓰기

결론

To reassemble your device, follow these instructions in reverse order.

JT Gryder

회원 가입일: 2013년 04월 12일

51 평판

안내서 1개 작성함

Cal Poly, Team 10-40, Amido Spring 2013 Cal Poly, Team 10-40, Amido Spring 2013 회원

CPSU-AMIDO-S13S10G40

4 회원들

안내서 20개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 4

지난 30일: 14

전체 시간: 814