기기를 수리하세요 커뮤니티 상점

이 안내서에는 최근 변경 사항이 더 있습니다. 최신 비검증 버전으로 전환하십시오.

Nintendo Wii Motherboard Cover Replacement

단지 전제 조건
이 안내서는 다른 가이드의 선행 작업으로 사용하기 위한 것입니다. 그 자체로는 불완전합니다.

필요한 것

  1. Nintendo Wii Motherboard Cover Replacement, Motherboard Cover: 1 단계, 이미지 1/1

    • Use a pair of tweezers to lift the fan connector up and out of its socket on the logic board.

    • Be sure your tweezers are clamped down on the fan connector, not the socket on the motherboard.

    번역하기

  2. Nintendo Wii Motherboard Cover Replacement: 2 단계, 이미지 1/2 Nintendo Wii Motherboard Cover Replacement: 2 단계, 이미지 2/2

    • Remove the two 10 mm Phillips screws securing the fan to the fan shroud.

    • Remove the fan from the Wii.

    번역하기

  3. Nintendo Wii Motherboard Cover Replacement: 3 단계, 이미지 1/2 Nintendo Wii Motherboard Cover Replacement: 3 단계, 이미지 2/2

    • Use the tip of a spudger or another fine-pointed tool to carefully pry one of the black plastic retaining fingers attached to the fan shroud away from the Wi-Fi antenna board.

    • Lift the Wi-Fi antenna out of the fan shroud.

    번역하기

  4. Nintendo Wii Motherboard Cover Replacement: 4 단계, 이미지 1/1

    • Remove the single 10 mm Phillips screw securing the second Wi-Fi antenna to the top of the fan shroud.

    번역하기

  6. Nintendo Wii Motherboard Cover Replacement: 5 단계, 이미지 1/1

    • Remove the two pieces of tape securing the second Wi-Fi antenna cable to the plastic bracket near the heat sink.

    번역하기

  7. Nintendo Wii Motherboard Cover Replacement: 6 단계, 이미지 1/1

    • Carefully de-route both antennas from the frame of the Wii and lay them aside.

    번역하기

  8. Nintendo Wii Motherboard Cover Replacement: 7 단계, 이미지 1/2 Nintendo Wii Motherboard Cover Replacement: 7 단계, 이미지 2/2

    • Remove the three 10 mm Phillips screws securing the fan shroud to the Wii.

    • Lift the fan shroud off the heat sink and remove it from the Wii.

    번역하기

  9. Nintendo Wii Motherboard Cover Replacement: 8 단계, 이미지 1/3 Nintendo Wii Motherboard Cover Replacement: 8 단계, 이미지 2/3 Nintendo Wii Motherboard Cover Replacement: 8 단계, 이미지 3/3

    • Remove the following six screws securing the EMI fingers to the bottom panel:

    • Four 7 mm Phillips screws

    • Two 11.3 mm Phillips screws

    • Remove both sets of EMI fingers from the Wii.

    번역하기

  10. Nintendo Wii Motherboard Cover Replacement: 9 단계, 이미지 1/2 Nintendo Wii Motherboard Cover Replacement: 9 단계, 이미지 2/2

    • Remove the following three screws:

    • One 7 mm Phillips screw

    • Two 10 mm Phillips screws

    • Lift the bracket out of the Wii.

    번역하기

  11. Nintendo Wii Motherboard Cover Replacement: 10 단계, 이미지 1/3 Nintendo Wii Motherboard Cover Replacement: 10 단계, 이미지 2/3 Nintendo Wii Motherboard Cover Replacement: 10 단계, 이미지 3/3

    • Remove the three 10 mm Phillips screws securing the black bracket to the bottom panel near the front of the Wii.

    • Slightly lift the bracket and use your other hand to pull the retaining clip away from where the Wi-Fi antennas enter the motherboard sheild.

    • Remove the bracket from the Wii.

    • Be sure not to lose the small square nut loosely held by the black plastic bracket.

    번역하기

  12. Nintendo Wii Motherboard Cover Replacement: 11 단계, 이미지 1/1

    • Remove the nine remaining 7 mm Phillips screws securing the motherboard cover to the bottom panel.

    번역하기

  13. Nintendo Wii Motherboard Cover Replacement: 12 단계, 이미지 1/1

    • Carefully lift the motherboard cover off the motherboard, minding any cables that may get caught.

    번역하기
결론

To reassemble your device, follow these instructions in reverse order.

작성자

다른 기여자 4명과 함께

Andrew Bookholt

586,263 평판

안내서 619개 작성하였습니다

배지: 47

배지 +44개 더

댓글 0개

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 0

30일 전: 1

전체 시간: 974