소개

Use this guide to remove the outer case of the Nintendo Wii U and gain access to the DVD drive.

With the bottom of the console facing up, remove the following 6 screws hidden underneath the white square stickers:
  • With the bottom of the console facing up, remove the following 6 screws hidden underneath the white square stickers:

    • Three 5.1mm Phillips #000 screws

    • Two 6.1mm Tri-wing Y0 screws

    • One 13.2mm Tri-wing Y1 screw

댓글 쓰기

Rotate the console 180 degrees so that the exhaust vents are facing you.
  • Rotate the console 180 degrees so that the exhaust vents are facing you.

  • Remove the two 7.1mm Phillips #00 screws.

Both screws are not “7.1mm” in length, only the one to the right is (center of the console’s side). The left one (towards the front of the console) is 5.1mm.

LogicalMadman - 답글

  • On the side opposite of the exhaust vents, slide the cover faceplate towards the back of the console and pull upwards to release it.

댓글 쓰기

  • On the bottom of the console beneath the previously removed faceplate, remove the three 13.2mm Tri-wing Y1 screws.

댓글 쓰기

  • On the back of the console, lift up and release the main top cover.

The front portion of the side of the cover with the vents was kind of stuck on mine. There’s a little rubber piece in there that was the cause of this. But that same rubber piece also makes up the little handle-shaped nub that sticks out of the side there. (There’s also one at the back of the same side, but that one didn’t stick for me.) Lifting also using the little handle made it easy to remove the cover.

Nicholas Halderman - 답글

결론

To reassemble your device, follow these instructions in reverse order.

다른 14명이 해당 안내서를 완성하였습니다.

Kim Arre

회원 가입일: 2013년 01월 11일

3,128 평판

안내서 8개 작성하였습니다

iFixit iFixit 회원

Community

112 회원들

안내서 6,710개 작성하였습니다

댓글 쓰기

조회 통계:

지난 24시간: 4

지난 7일: 30

지난 30일: 151

전체 시간: 15,818