주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

소개

This guide will show you how to take apart and replace the Wii U Pro Controller's secondary trigger buttons, the ZL and ZR buttons.

  1. Turn the controller over to reveal the battery cover.
    • Turn the controller over to reveal the battery cover.

    • Use the J000 screwdriver to remove the screw that secures the battery cover.

  2. Remove the battery from the controller by inserting the plastic spudger into the small gap on the bottom right of the battery. Use the spudger as a lever to pry up and remove the battery from the compartment.
    • Remove the battery from the controller by inserting the plastic spudger into the small gap on the bottom right of the battery.

    • Use the spudger as a lever to pry up and remove the battery from the compartment.

  3. Manta(만타) 드라이버 키트

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta(만타) 드라이버 키트

    Upgrade Your Toolbox
  4. Once the battery has been removed, we will remove the 4 screws in the battery compartment and then the 4 screws around the back of the case.  These 8 screws use the Y0 bit.  Each of these screws are 5.5 mm.
    • Once the battery has been removed, we will remove the 4 screws in the battery compartment and then the 4 screws around the back of the case. These 8 screws use the Y0 bit. Each of these screws are 5.5 mm.

    • The four screws on the outside are extremely deep into the casing, and the holes are pretty small. You will need to use a 4 mm driver bit extension to reach these screws.

  5. Once all of the screws are removed, simply use one hand to hold the front panel in place and lift up on the back panel to remove it.  Place the back panel so the insides are facing up towards you.
    • Once all of the screws are removed, simply use one hand to hold the front panel in place and lift up on the back panel to remove it. Place the back panel so the insides are facing up towards you.

  6. Locate the two triggers (ZL and ZR) and pop them up and out by pressing on them from the outside. Locate the two triggers (ZL and ZR) and pop them up and out by pressing on them from the outside.
    • Locate the two triggers (ZL and ZR) and pop them up and out by pressing on them from the outside.

결론

To reassemble your device, follow these instructions in reverse order.

Jesse Burton

회원 가입일: 2015년 09월 17일

504 평판

안내서 3개 작성하였습니다

IUPUI, Team 2-2, Harley Fall 2015 IUPUI, Team 2-2, Harley Fall 2015 회원

IUPUI-HARLEY-F15S2G2

4 회원들

안내서 5개 작성하였습니다

댓글 쓰기

조회 통계:

24 시간 전: 0

7일 전: 10

30일 전: 52

전체 시간: 3,130